Cisco Systems 3130 User Manual

Page of 1226
 
39-20
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 39      Configuring IPv6 Unicast Routing
Configuring IPv6
To remove a configured static route, use the no ipv6 route ipv6-prefix/prefix length {ipv6-address | 
interface-id 
[ipv6-address]} [administrative distance] global configuration command.
This example shows how to configure a floating static route to an interface with an administrative 
distance of 130:
Switch(config)# ipv6 route 2001:0DB8::/32 gigabitethernet2/0/1 130
For more information about configuring static IPv6 routing, see the “Implementing Static Routes for 
IPv6” chapter in the Cisco IOS IPv6 Configuration Library at this URL:
Configuring RIP for IPv6
Routing Information Protocol (RIP) for IPv6 is a distance-vector protocol that uses hop count as a 
routing metric. IPv6 RIP functions the same and offers the same benefits as RIP in IPv4. IPv6 RIP 
enhancements include support for IPv6 addresses and prefixes and the use of the all-RIP-routers 
multicast group address FF02::9 as the destination address for RIP update messages.
Each IPv6 RIP process maintains a local routing table, referred to as a Routing Information Database 
(RIB), that contains a set of best-cost IPv6 routes learned from all its neighboring networking devices. 
If IPv6 RIP learns the same route from two different neighbors, but with different costs, it stores only 
the lowest-cost route in the local RIB. The RIB also stores any expired routes that the RIP process is 
advertising to its neighbors that are running RIP. If the same route is learned from a different routing 
protocol with a better administrative distance than IPv6 RIP, the RIP route is not added to the IPv6 RIB, 
but the route still exists in the IPv6 RIP RIB.
Note
Before configuring the switch to run IPv6 RIP, you must enable routing by using the ip routing global 
configuration command, enable the forwarding of IPv6 packets by using the ipv6 unicast-routing global 
configuration command, and enable IPv6 on any Layer 3 interfaces on which IPv6 RIP is to be enabled.
Step 4
show ipv6 static [ipv6-address | 
ipv6-prefix/prefix
 length] [interface 
interface-id] [recursive] [detail]
or
show ipv6 route static [updated
Verify your entries by displaying the contents of the IPv6 routing 
table.
interface interface-id—(Optional) Display only those static 
routes with the specified interface as an egress interface.
recursive—(Optional) Display only recursive static routes. The 
recursive keyword is mutually exclusive with the interface 
keyword, but it can be used with or without the IPv6 prefix 
included in the command syntax. 
detail—(Optional) Display this additional information:
For valid recursive routes, the output path set, and 
maximum resolution depth.
For invalid routes, the reason why the route is not valid.
Step 5
copy running-config startup-config 
(Optional) Save your entries in the configuration file.
Command
Purpose