Cisco Systems 3130 User Manual

To disable an OSPF routing process, use the no ipv6 router ospf process-id global configuration 
command. To disable the OSPF routing process for an interface, use the no ipv6 ospf process-id area 
area-id interface configuration command.

For more information about configuring OSPF routing for IPv6, see the “Implementing OSPF for IPv6” 
chapter in the Cisco IOS IPv6 Configuration Library at this URL:

 shows the privileged EXEC commands for monitoring IPv6 on the switch.

This is an example of the output from the show ipv6 interface privileged EXEC command:

Switch# show ipv6 interface

Vlan1 is up, line protocol is up

  IPv6 is enabled, link-local address is FE80::20B:46FF:FE2F:D940

  Global unicast address(es):

    3FFE:C000:0:1:20B:46FF:FE2F:D940, subnet is 3FFE:C000:0:1::/64 [EUI]

  Joined group address(es):

    FF02::1

    FF02::2

    FF02::1:FF2F:D940

  MTU is 1500 bytes

  ICMP error messages limited to one every 100 milliseconds

  ICMP redirects are enabled

  ND DAD is enabled, number of DAD attempts: 1

  ND reachable time is 30000 milliseconds

  ND advertised reachable time is 0 milliseconds

  ND advertised retransmit interval is 0 milliseconds

Display a summary of access lists.

Display Cisco Express Forwarding for IPv6.

show ipv6 interface interface-id 

Display IPv6 interface status and configuration.

show ipv6 mtu 

Display IPv6 MTU per destination cache.

Display IPv6 neighbor cache entries.

Display IPv6 OSPF information.

show ipv6 prefix-list 

Display a list of IPv6 prefix lists.

Display IPv6 routing protocols on the switch.

Display IPv6 RIP routing protocol status.

Display the IPv6 route table entries.

show ipv6 routers 

Display the local IPv6 routers.

Display IPv6 static routes.

Display IPv6 traffic statistics.