Cisco Systems 3130 User Manual
40-4
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 40 Configuring HSRP
Configuring HSRP
Figure 40-2
MHSRP Load Sharing
HSRP and Switch Stacks
HSRP hello messages are generated by the stack master. If an HSRP-active stack master fails, a flap in
the HSRP active state might occur. This is because HSRP hello messages are not generated while a new
stack master is elected and initialized, and the standby router might become active after the stack master
fails.
the HSRP active state might occur. This is because HSRP hello messages are not generated while a new
stack master is elected and initialized, and the standby router might become active after the stack master
fails.
Configuring HSRP
These sections contain this configuration information:
•
•
•
•
•
•
2
01791
Active router for group 1
Standby router for group 2
Standby router for group 2
Blade switch
enclosure
with a
management
module
Router A
Router B
10.0.0.1
Active link
Standby link
Active link
Standby link
10.0.0.2
Active router for group 2
Standby router for group 1
Standby router for group 1
Blade switch
enclosure
with a
management
module