Cisco Systems 3130 User Manual

Page of 1226
 
42-6
Cisco Catalyst Blade Switch 3130 for Dell Software Configuration Guide
OL-13270-01
Chapter 42      Configuring Enhanced Object Tracking
Configuring Enhanced Object Tracking Features
Beginning in privileged EXEC mode, follow these steps to configure a tracked list of objects by using a 
percentage threshold:
Use the no track track-number global configuration command to delete the tracked list.
This example configures tracked list 4 with three objects and a specified percentages to measure the state 
of the list: 
Switch(config)# track 4 list threshold percentage
Switch(config-track)# object 1 
Switch(config-track)# object 2 
Switch(config-track)# object 3 
Switch(config-track)# threshold percentage up 51 down 10
Switch(config-track)# exit
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
track track-number list threshold 
percentage
Configure a tracked list object and enter tracking configuration mode. The 
track-number can be from 1 to 500. 
threshold—Specify the state of the tracked list based on a threshold.
percentage—Specify that the threshold is based on percentage.
Step 3
object object-number
Specify the object to be tracked. The range is from 1 to 500. 
Note
An object must exist before you can add it to a tracked list. 
Step 4
threshold percentage {up number | 
[down number]}
Specify the threshold percentage. 
up number—The valid range is from 1 to 100.
down number]—(Optional) The range depends on the number selected 
for the up number. If you configure the up number as 25, the range 
shown for the down number is 0 to 24. 
Step 5
delay {up seconds [down seconds] | 
[up secondsdown seconds}
(Optional) Specify a period of time in seconds to delay communicating state 
changes of a tracked object. The range is from 1 to 180 seconds.
Step 6
end
Return to privileged EXEC mode.
Step 7
show track object-number
Verify that the specified objects are being tracked.
Step 8
copy running-config startup-config (Optional) Save your entries in the configuration file.