Enterasys Networks 2S4082-25-SYS User Manual

7C111 Chassis Specifications and Regulatory Compliance

Enterasys NAC Controller Hardware Installation Guide A-3

 provides the Input/Output ports, processor and memory, physical, and environmental 

specifications for the NAC Controller Engine (same on both ‐SYS models). 

External Gigabit Ethernet Ports (2)

When referring to these ports with NAC Controller PEP CLI 
commands, use the following syntax to designate port type, 
slot location, and port number:

ge.1.port#

where ge is the port type, 1 specifies the the slot location of 
the single-slot NAC Controller PEP within the chassis, and 
port# is the port number. The port # will be designated as 
the next sequential ge port after the last ge port on the NAC 
Controller PEP. 

Mini-GBIC slots can be mix-and-match, 1000BASE-SX, -LX, 
-ELX and 1000BASE-T compliant Minii-GBICs. Refer to 
“

Internal Gigabit Ethernet Ports (2)

The two internal ports connect to the on-board processor 
and are used by the installed NAC Controller Engine 
software. These ports have the same capabilities as any 
other NAC Controller PEP port.

When referring to these ports with NAC Controller PEP CLI 
commands, use the following syntax to designate port type, 
slot location, and port number:

pc.1.port#

where pc is the port type, 1 specifies the the slot location of 
the single-slot NAC Controller PEP within the chassis, and 
port# is the port number, either 1 or 2.

RS 232 Serial COM Port

Provides connection for Local Management. This port may 
be used for NAC Controller initialization.

VGA Port 

Provides display monitor connection.

10/100 Ethernet Port

Can be used for NAC Controller initialization, management, 
or network connection.

USB Port

Provides USB connection.

Processor

Pentium M 14 GHz Processor

Dynamic Random Access Memory 
(DRAM)

1 GB 

Hard Drive 

60 GB 2.5 inch drive

AC Input Voltage

100—200V

AC Input Amps

1.5A

Frequency

50-60Hz