Fujitsu RX900 S1 User Manual

262

Maintenance Manual

 RX900 

S1

To allow permanent saving of the system information, a lithium battery is 
installed which supplies the CMOS memory with power. If the battery voltage is 
too low or the battery is empty, a corresponding error message is displayed. The 
lithium battery must then be replaced.

V

The lithium battery must be replaced with an identical battery or with a 
battery type recommended by the manufacturer. This information doesn’t 
apply to the Japanese market.

Do not throw lithium batteries into the trash can. They must be disposed 
of in accordance with local regulations on special waste.

Make sure you insert the lithium battery the right way round – the 
positive pole must be on the housing side!

●

Starting and completing the task:

–

key for the rack doors (if applicable)

–

Phillips Ph2 screw driver

●

Replacing the battery: tool-less

Authorized specialist personnel can carry out replacement tasks for 
integral server components. Ask you local Fujitsu service center for 
more detailed information.

V

Procedures indicated as "Authorized personnel only“ must be 
done by Fujitsu service personnel or technicians trained by 
Fujitsu for doing these tasks. Please note that unauthorized 
interference with the system will void the warranty and exempt the 
manufacturer from all liability.