Fujitsu TX200 S6 User Manual

TX200 S6

Operating Manual

49

V

●

Please observe the safety information and notes on rack mounting in 

.

●

At least two people are needed to install / remove the server in the 
rack. (For the Japanese market, please refer to "

安全上の注意および

その他の重要情報

".)

●

The rack may tip over if more than one unit is removed at the same 
time.

●

The server may not occupy the top height units of the rack 
(38HU/42HU PRIMECENTER Rack, DataCenter Rack, 
19-inch standard rack (for the Japanese market)), 
as otherwise boards cannot be replaced even with the plug-in module 
fully extended.

The rack systems from Fujitsu PRIMECENTER Rack, DataCenter Rack and 
19-inch standard rack (for the Japanese market) support the installation of 
PRIMERGY servers. Installation in most current rack systems from other 
manufacturers (3rd party racks) is also supported.

To accommodate the ventilation concept and ensure proper ventilation, any 
unused areas in the rack must be sealed using dummy covers.

The power is supplied via the multiple socket outlets fitted in the rack. 

The main features of PRIMECENTER Rack, DataCenter Rack and 19-inch 
standard rack (for the Japanese market) are as follows:

–

support systems that can be mounted without tools

–

support systems having a linear alignment feature to ensure that they can 
be adjusted to different rack depths

PRIMECENTER Rack and DataCenter Rack provide an enhanced cable 
management in the lateral rack area.