Perle Systems SCS8C DC User Manual

RADIUS and TACACS+  382

RADIUS

When authentication is being done by RADIUS, there are several 

 and 

 parameters 

that can be set by the RADIUS server. Any parameters sent by that RADIUS server that are not 
supported by the IOLAN are discarded. Below is a list of the RADIUS parameters and their IOLAN 
parameters:

46

Acct-Session-Time

Number of seconds for which the user has been 

connected to a specific session.

47

Acct-Input-Packets

Number of packets which were received from the user 
during this session.

48

Acct-Output-Packets

Number of packets which were transmitted to the user 

during this session.

49

Acct-Terminate-Cause Indicates how the session was terminated: Supported 

values include: 1 = User Request 2= Lost Carrier 
3=Lost Service 4= Idle Timeout 5= Session Timeout 

 

14 = Port Suspended 16 = Callback.

61

NAS-Port-Type

For reverse telnet and reverse ssh connections, a type of 

Virtual (5) will be sent. For a PPP connection type a 
type of Async (0) will be sent. For all direct connect 

service types a type of Async (0) will be sent.

77

Connect-Info

.For reverse telnet, reverse ssh and direct serial 

connections the serial port baud rate is send to the radius 
accounting server.

87

NAS-Port-Id

For sessions originating from the serial port:

<line-name> or “SERIAL:xx”, where xx starts at 
serial port 1.

For reverse Telnet and SSH Ethernet sessions:

“ETH:REVSESS:xx”, where xx is the serial port 

being accesses, otherwise 00 for a ILOAN 

management session.

For Device manager sessions: 

“DEVMGR”

For HTTP sessions:

“HTTP”

95

NAS-IPv6-Address

The IPv6 address of the IOLAN

98

Login-IPv6-Host

For LOGIN and CALLBACK service types, the IPv4 
address of the login host is sent to the radius accounting 

host.

Service-Type

This has no IOLAN field, although it needs 

to be set to 

 in the RADIUS 

server if the port is set for PPP or SLIP. For 
a Console Management profile set the 

RADIUS Service-Type to NAS prompt.

Framed-Protocol

Set to SLIP or PPP service.