Citrix Systems 6 User Manual
130
Get a Xen
dmesg
(the output of the kernel ring buffer) from specified XenServer hosts.
The host(s) on which this operation should be performed are selected using the standard selection mechanism
(see
(see
above). Optional arguments can be any number of the
of this section.
host-emergency-management-reconfigure
host-emergency-management-reconfigure
interface=
<uuid_of_management_interface_pif>
Reconfigure the primary management interface of this XenServer host. Use this command only if the XenServer
host is in emergency mode, meaning that it is a member in a resource pool whose master has disappeared from
the network and could not be contacted for some number of retries.
host is in emergency mode, meaning that it is a member in a resource pool whose master has disappeared from
the network and could not be contacted for some number of retries.
host-enable
host-enable
[
<host-selector>
=
<host_selector_value>
...]
Enables the specified XenServer hosts, which allows new VMs to be started on them.
The host(s) on which this operation should be performed are selected using the standard selection mechanism
(see
(see
above). Optional arguments can be any number of the
of this section.
host-evacuate
host-evacuate
[
<host-selector>
=
<host_selector_value>
...]
Live migrates all running VMs to other suitable hosts on a pool. The host must first be disabled using the host-
disable command.
disable command.
If the evacuated host is the pool master, then another host must be selected to be the pool master. To change
the pool master with HA disabled, you need to use the pool-designate-new-master command. See
the pool master with HA disabled, you need to use the pool-designate-new-master command. See
which will cause HA to elect a new master at random. See
.
The host(s) on which this operation should be performed are selected using the standard selection mechanism
(see
(see
above). Optional arguments can be any number of the
of this section.
host-forget
host-forget
uuid=
<XenServer_host_UUID>
The
xapi
agent forgets about the specified XenServer host without contacting it explicitly.
Use the
--force
parameter to avoid being prompted to confirm that you really want to perform this operation.
Warning:
Do not use this command if HA is enabled on the pool. Disable HA first, then enable it again
after you've forgotten the host.
after you've forgotten the host.
Tip:
This command is useful if the XenServer host to "forget" is dead; however, if the XenServer
host is live and part of the pool, you should use xe pool-eject instead.
host is live and part of the pool, you should use xe pool-eject instead.
host-get-system-status
host-get-system-status
filename=
<name_for_status_file>
[entries=
<comma_separated_list>
] [output=
<tar.bz2 | zip>
] [
<host-selector>
=
<host_selector_value>
...]