GE GFK0579B User Manual

Chapter 1 Introduction

Series 90–70 Power Supplies

These Series 90–70 Power Supplies can be used in a remote drop:

H IC697PWR710, 120/240 VAC input, +5 VDC output, 55 Watts (shown below)
H IC697PWR711, 120/240 VAC input, +5 VDC, +12 VDC, –12 VDC output, 100 Watts
H IC697PWR721, 24VDC input, +5 VDC, +12 VDC, –12 VDC output, 90 Watts
H IC697PWR731, 125VDC input, +5 VDC, +12 VDC, –12 VDC output, 60 Watts

OFF

EVEN IF THE POWER SUPPLY

IS SWITCHED OFF, HAZARDOUS

VOLTAGES FROM USER FIELD

WIRING MAY STILL BE PRESENT

ON THE I/O TERMINAL BOARDS

AS WELL AS THE POWER

SUPPLY TERMINAL BOARD.

CARE SHOULD BE TAKEN WHEN

HANDLING THE POWER SUPPLY

AND I/O MODULES AS WELL AS

ANY WIRING CONNECTED TO

THEM IN ORDER TO PREVENT

PERSONAL INJURY.

a42818

BRANCH CIRCUIT FUSING
MUST BE PROVIDED
EXTERNALLY

LED

120

SHORT FOR 120
OPEN FOR 240

SELECT

240

INPUT

RECOMMENDED TIGHTENING
TORQUE 1,5Nm (15kg cm)

OUTPUT

INPUT

5V
11A

120/240V AC
50/60HZ
1.5/0.8A

POWER SUPPLY MODULE

ÎÎ

DO NOT REMOVE OR INSERT

MODULES WITH POWER APPLIED.

PERSONAL INJURY, SYSTEM

MALFUNCTION AND/OR DAMAGE

TO THE EQUIPMENT MAY OCCUR.

WARNING

MODEL 70

PWR 710

MODULE IC697PWR710
LABEL 44A726758–501

WARNING

Power supply selection will depend on the input power and load requirements of the
application. Load specifications for Series 90–70 modules are listed on page 9.

AC power supplies mount in the leftmost slot of a Series 90–70 rack. DC power
supplies can be mounted on the side of the rack or used as freestanding modules. The
DC power supplies require a power supply adapter, which installs in the power supply
slot and is connected to the power supply by a short cable.