Symbol Technologies 72E-86039-04 User Manual
Scanning
2 - 3
Fast warble beep
Aborting MPDF sequence.
Low/high beeps
Flushing an already empty MPDF buffer.
ADF Programming: Normal Data Entry. Duration of tones are short.
High/low beeps
Enter another digit. Add leading zeros to the front if necessary.
Low/low beeps
Enter another alphabetic character or scan the End of Message bar code.
High/high beeps
Enter another criterion or action, or scan the Save Rule bar code.
High/low/high/low beeps
Rule saved. Rule entry mode exited.
High/low/low beeps
All criteria or actions cleared for current rule, continue entering rule.
Low beep
Delete last saved rule. The current rule is left intact.
Low/high/high beeps
All rules are deleted.
ADF Programming: Error Indications. Duration of tones are very long.
Low/high/low/high beeps
Out of rule memory. Erase some existing rules, then try to save rule again. (It is not
necessary to re-enter the current rule.)
necessary to re-enter the current rule.)
Low/high/low beeps
Cancel rule entry. Rule entry mode exited because of an error or the user asked to
exit rule entry.
exit rule entry.
Low/high beeps
Entry error, wrong bar code scanned. Re-enter criterion or action. All previously
entered criteria and actions are retained. Criteria or action list is too long for a rule.
entered criteria and actions are retained. Criteria or action list is too long for a rule.
Host Specific
USB only
4 short high beeps
Digital scanner has not completed initialization. Wait several seconds and scan
again.
again.
Low/medium/high beeps
upon scanning a USB device
type
type
Communication with the bus must be established before the digital scanner can
operate at the highest power level.
operate at the highest power level.
Low/medium/high beeps
occur more than once.
The USB bus can put the digital scanner in a state where power to the digital
scanner is cycled on and off more than once. This is normal and usually happens
when the PC cold boots.
scanner is cycled on and off more than once. This is normal and usually happens
when the PC cold boots.
RS-232 only
1 short high beep
A <BEL> character is received and Beep on <BEL> is enabled.
Table 2-1
Beeper Definitions (Continued)
Beeper Sequence
Indication