Sony SNT-V304 User Manual

19

Purpose

Pan Tilt

HSR (only
displayed for
COM1)

Purpose

Serial
Mode
(only
displayed
for
COM1)

Baud
Rate
(bps)

Data Bits
(length)

Stop Bits

Parity Bit

Select this if an EVI-D30/
D31/G20/G21 is connected to
the port.
When selected, the “Pan Tilt”
icon shown below is added
next to the “COM1” or
“COM2” icon.

Select this if an HSR-1/1P/2/
2P is connected to the port.
When selected, the “HSR”
icon shown below is added
next to the “COM1” icon.

The 

 

 (COM1 and COM2) icons represent the

serial ports of the video network station. Use these
icons when an EVI-D30/D31/G20/G21 or HSR-1/1P/
2/2P is connected to the “COM1” or “COM2” ports to
set up serial port function and communications
parameters.

If a serial port has the Click “Save” icon enabled, the
video network station reboots and alarm memory
contents are erased, so check the alarm memory
contents, if necessary, before setting.

Click the “COM1” (or “COM2”) icon.
The screen displays the “Serial Port 1 Settings” (or
“Serial Port 2 Settings”).

Make the required settings. Available settings are
as follows.

z 

Only an HSR-1/1P/2/2P or a modem can be
connected to the video network station at any given
time. Accordingly, when [COM1] is set to [HSR]
or [COM2] set to [Modem], the other option button
is not displayed.

Click the “Save” icon when finished with the
settings.
The new settings are saved, the video network
station reboots, and the display changes as follows
depending on the selected usage.
• When [Pan Tilt] is selected, the “Pan Tilt

Settings” page appears. Refer to “Pan/Tilt Driver
and Video Camera ID Setup” below.

• When [HSR] is selected, the “Sony HSR

Settings” page appears. Refer to “HSR-1/1P/2/2P
Setup” on page 21.

Select this if a modem is
connected to the port.
When selected, the “Modem”
and “ISP” icons shown below
are displayed.

 

Select if using a CGI/Generic
driver.
When selected, the following
“Generic” icon is added next
to the [COM1] or [COM2]
icon.

Select this if no device is
connected to a port.

Select the appropriate interface type:
[RS232] for the EVI-D30/D31/G20/G21 and
HSR-1/1P/2/2P.

Select the transfer speed: Select [9600]
when the device supports EVI-D30/D31/
G20/G21 or Kalatel protocol, or [9600] to
[38400] as the HSR setting to match that of
the HSR-1/1P/2/2P.

Select [8] data bits when the device
supports EVI-D30/D31/G20/G21, HSR-1/
1P/2/2P, or Kalatel protocol.

Select [1] stop bit when the device supports
EVI-D30/D31/G20/G21, HSR-1/1P/2/2P, or
Kalatel protocol.

Select [None] when the device supports
EVI-D30/D31/G20/G21, HSR-1/1P/2/2P, or
Kalatel protocol.

Modem
(only
displayed for
COM2)

Generic

None