Wacom DTK-2200 User Manual

24

24

CONFIGURING CINTIQ FOR HANDEDNESS

During the installation process, you were prompted to choose a default configuration for Cintiq based on 
whether you are right- or left-handed.  The configuration you chose was used to determine the default 
settings for the ExpressKeys and Touch Strips.

However, you can use the Wacom Tablet control panel to easily reconfigure Cintiq for left- or right-handed 
users at any time.  The ExpressKey and Touch Strip settings are automatically reconfigured when you 
change the handedness setting.

USING THE GRIP PEN

The cordless, battery-free pen senses the amount of pressure and tilt you apply to the tip.  There are four 
basic techniques for using the pen: pointing, clicking, double-clicking, and dragging.  If you are unfamiliar 
with using the pen, see the following pages.

Holding the pen
Positioning
Clicking
Dragging
Using the side switch
Working with pressure sensitivity
Drawing with tilt
Erasing

To reconfigure for left- or right-handed users:

1.

Launch the Wacom Tablet control panel by pressing the center 

. Click O

PTIONS

....

2.

Choose the appropriate setting for your preferred handedness.

3.

Click OK.  The existing ExpressKey and Touch Strip settings are 
swapped (or flipped) between left and right.

Notes:

The hardware control buttons are not affected when you 
change the handedness setting.

Likewise, changing the handedness setting does not affect the 
ExpressKeys used to control the LCD settings when in LCD 
settings (OSD) mode.

This procedure does not affect the default orientation.  At the 
system log on and user switching screens, the pen display uses 
the default configuration you chose during the install process.  
To change the default configuration, you must re-install the 
Wacom driver.