Napoleon Fireplaces GSST8N User Manual

Page of 16
2
W415-0689 / 06.25.08
!
WARNING
 PG 2-5  INTRODUCTION
 
  
 
  Warranty
  
 
  General Instructions
   
 
  General Information / Rates and Effi ciencies
   
 
   Care of Glass and Plated Parts
  
 
  Dimensions
5-7   
INSTALLATION
 
   
  
 
  Gas Installation
  
 
  Electrical Connection
   
 
  Clearance to Combustibles
8-11  
FINISHING
   
 
  TMCSS Mounting Cabinet Installation 
  
 
  Rain Tabs
  
 
  Door Removal
  
 
  Glass Removal
   
 
  TFSSO Frame Installation
  
 
  Logo Placement
   
 
  Accent Glass Installation
   
 
  LK8 Light Installation (Optional)
TABLE of CONTENTS
NOTE:  Changes, other than editorial, are denoted by a line in the margin.
 12  
OPERATING INSTRUCTIONS
    
 13  
MAINTENANCE
  
 
  Cleaning
 
 13  
ADJUSTMENTS
  
 
  Gas Pressure Adjustment
  
 
  Venturi Adjustment
  
 
  Flame Characteristics
14  
REPLACEMENTS
    
 
Replacement 
Parts
  
 
  Accessories 
15  
TROUBLE SHOOTING GUIDE
16  
SERVICE HISTORY
Improper installation, adjustment, alteration, service or maintenance can cause 
injury or property damage.  Read the installation, operating, and maintenance 
instructions thoroughly before installing or servicing this equipment.
•  Do not burn wood or other materials in this enclosure.
•  Adults and especially children should be alerted to the hazards of high surface temperatures and should stay away   
  to avoid burns or clothing ignition. Supervise young children when they are in the same area as the enclosure.
•  Clothing or other fl ammable material should not be placed on or near the enclosure.
•  Due to high temperatures, the enclosure should be located out of traffi c.
•  Ensure you have incorporated adequate safety measure to protect infants/toddlers from touching hot surfaces.
•  Even after the appliance is out, the glass and/or screen will remain hot for an extended period of time.
•  Check with your local hearth specialty dealer for safety screens and hearth guards to protect children from hot  
 
 surfaces. 
•  Any safety screen or guard removed for servicing must be replaced prior to operating the enclosure.
•  It is imperative that the control compartments, burners and circulating blower and its passageway in the enclosure is
  kept clean.  The appliance should be inspected before use and at least annually by a qualifi ed service person.  The 
  enclosure area must be kept clear and free from combustible materials, gasoline and other fl ammable  
 
 
  vapours and liquids.
•  Under no circumstances should this enclosure be modifi ed.
•  Do not use this enclosure if any part has been under water. Immediately call a qualifi ed service technician to inspect  
  the enclosure and to replace any part of the control system and any gas control which has been under water.
•  Do not operate the appliance with cracked or broken glass. Replacement of the glass should be done by a licensed  
 or 
qualifi ed service person.
•  Do not strike or slam shut the enclosure glass doors.
•  Provide adequate ventilation and combustion air.  Refer to unvented room heaters installation instructions.  Never    
  obstruct the front opening of the enclosure.
•  Furniture or other objects must be kept a minimum of 4 feet away from the front of the enclosure.
•  Do not use a blower insert, heat exchanger insert or other accessory not approved for use with this enclosure.
•  This appliance is only for use with the type of gas indicated on the rating plate.
•  The gas log heater must be secured to the enclosure fl oor to ensure that the position is not changed while adjusting  
 controls.
•  Only doors / optional fronts certifi ed with the unit are to be installed on the appliance.
•  This enclosure uses and requires a fast acting thermocouple. Replace only with a fast acting thermocouple supplied  
  by Wolf Steel Ltd.
•  The burner must be replaced prior to the appliance being put into operation if it is evident the burner is damaged.     
  Replace only with a burner supplied by Wolf Steel Ltd.
!
WARNING