Genie 3062m3064 User Manual

PRGM

SET

Remote Control Programming

REMOTES

NOTE: THE REMOTE CONTROLS INCLUDED WITH THIS OPENER, HAVE

BEEN PRE-PROGRAMMED AT THE FACTORY FOR YOUR CONVENIENCE.
NOTE: The following instructions are for remote control transmitters purchased

separately in addition to those provided with this opener, but

can also be used if any remote(s) may require re-programming.
NOTE: Each programming step has a 30 second time limit for completion

after the function is initiated. After 30 seconds, two LED’s will illuminate RED

indicating time has expired and the step must be re-started. Restart the step as

many times as necessary to complete the programming.
NOTE: Do NOT hold Remote too close to the Powerhead when programming

Remote buttons.
NOTE: Each button on each Remote must be programmed separately,

following these steps.
1. Remove the battery’s protective film from the remote by

pulling it straight out.

Press and hold the program button on the opener for two

seconds until the round LED turns blue, then release. The long

purple LED will flash.

Flashing Purple

Slowly press and release the remote button two times. The

opener LEDs will flash and go off, indicating it has been

successfully programmed to the remote.

Press and release the same button a third time and door will

open or close.

NOTE: While programming remote buttons, stand at least 5 feet away from

the powerhead. This ensures you have proper communication between the

remote and the powerhead.

To program the same remote for other garage door openers, repeat

the steps above using one of the other remaining remote buttons.

REPEAT STEPS 1 TO 4 FOR EACH OPENER AND REMOTE

NOTE: It is possible to press the remote button too quickly or lightly. If the

LEDs do not go off, press the remote button several more times to achieve

confirmation.

BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR

OPENER IS READY TO USE.

FCC and IC Certified

This device complies with FCC Part 15 and Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions: (1)

this devise may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of

the device. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular situation. If this equipment does

cause harmful interference to radio or television reception, which may be determined by turning equipment OFF and ON, the user is encouraged to try and correct

the interference by one or more of the following measures: (a) Re-orient or relocate the receiver antenna, (b) Increase the separation between the opener and

receiver, (c) Connect the opener into an outlet on a circuit different from that which the receiver is connected, and (d) Consult your local dealer. Any modification or

changes to this equipment which is not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

This device complies with the Health Canada’s Safety Code. The installer of this device should ensure that the RF radiation is not emitted in excess of the Health

Canada’s requirement. Information can be acquired at: http://www.hc-sc.gc.ca/ewh-semt/radiation/cons/wifi/index-eng.php

PRGM

SET