GE GSD6600 User Manual

– 14 –

Removal

1. Remove the outer door panel 

(see 

nents).

2. Open the door and remove the 3 screws from

the back on the right side of the escutcheon
keypad assembly.

3. Remove 1 screw from the right side of the

control module and slide the module out.

4. Unplug the connectors from the module.

Installation

Note: The gray cable is a factory test cable (see
photo) and may be removed when servicing
control module.

1. Plug connectors into control module.

2. Insert the tabs on the left side of the control

module into the slots on the inner door panel
and secure the module with 1 screw.

3. Install 3 screws on the right side of the escutch-

eon and replace the outer door panel 

(see 

Components).

The door panel must be removed to access the
detergent/rinse module. Refer to the 

 section.

The detergent/rinse module can be activated using
service mode. Refer to the 

 chapter.

The detergent/rinse module automatically dis-
penses both the detergent and the rinse agent at
the appropriate times. The module is activated 2
times during a wash cycle.

The first time the module is activated (1), the lever
slides up the right-hand path of the connecting rod.
This action releases the detergent cover. When
deactivated (2), the lever returns down the left-
hand path and comes to rest under the notch in
the center of the connecting rod. At the second
activation (3), the lever lifts the connecting rod by
the notch. This action lifts the rinse dispenser
plunger and releases the rinse agent. When
deactivated, the lever returns to its original starting
position.

Cover
latch

Pre-wash
section

Main
wash
section

Cover

Indicator
window

Dispenser cap

Rinse
agent
adjuster

P0003697

J2-6

RY

WR

1200-2800

DETERGENT MODULE

NO

N

COM

WX

DOOR

INTERLOCK