Fisher & Paykel DD60ST 7 User Manual

Check all parts are installed.
Ensure that all panels and parts thereof are secure and final electrical tests have 

been conducted in accordance with local electrical regulations.

Ensure product is level, securely fastened to the cabinetry and opens and 

closes freely. The drawer must be free to fully close with no resistance from the 

cabinetry.

Ensure inlet hose to water supply has supplied rubber washer fitted, and that 

it’s tightened a further half turn after seal contact.

Ensure any knockouts or plugs in drain connection have been drilled out and 

drain connection has been made.

The drain hose joiner must not support the weight of excess hose material. 

Keep drain hose as fully extended as possible to prevent sagging. Any excess 

length of drain hose should be kept on the dishwasher side of the highloop.

If connecting the drain hose to the sink trap, ensure the Highloop is a minimum 

150 mm higher than the drain hose joiner.

Ensure any packaging or tape securing the racks is removed from the drawer.

Turn on the power and water supplies, then open the drawer. You should hear a 

beep and see a program indicator light up on the internal control panel.

Check the spray arm is in place and free to rotate.

Add three cups of water into the drawer. Press 

 on the internal control panel 

until the indicator of the ‘Rinse’ program lights up. Close the drawer and press 

 to start the program.

After the Rinse program has finished, ensure the dishwasher has run and 

drained correctly.

Check water supply and drainage connection for leakage.

Spray arm

Check for a kinked drain hose, blocked waste connection, highloop not 
properly installed, drain hose not routed correctly or spray arm not in place.

Check water is connected and turned on.

 

There is a fault. See section ‘If there is a fault’ in the User guide for further 
information and instructions.

Ensure power is connected and is switched on. If it is and still no indicator 
ligths up, see the ‘Preference options’ section of the ‘Quick start guide’. An 
option called ‘Open drawer auto power-on’ may need to be turned on.

 

Check connections, existing plumbing and hoses for leaks. Check rubber 
washer and hose clamp are correctly fitted.

Ensure the product is secured to the cabinetry. 

Check and relevel product. Check the cabinetry is square. For Integrated 
models, check and adjust front panel alignment if necessary.

Ensure nothing is obstructing the drawer from closing properly eg sound 
insulation, hoses or drawer latches.

  If a problem occurs, consult the ‘Troubleshooting’ section of the User guide.
  If after checking these points you still need assistance, please refer to the 

Service & Warranty book for warranty details and your nearest Authorised 
Service Centre, or contact us through our website, listed below.