Jackson JP-24 User Manual

JP-24 Technical Manual 7610-002-49-79 Rev. D

Issued: 03-06-2006  Revised: N/A

50

Instructions for Adding Cycle Counter to JP -24 Undercounter Dish Machine 
 

1.  Locate the template on the front of the plastic control panel in the approximate location as 

shown in the diagram below.  

2.  Use a 3/32” diameter drill bit to drill the four mounting holes through the plastic control 

panel. 

3.  Mount the template to the front of the control panel using the screws and locknuts provided. 

4.  Using the template as a guide, cut the 1-3/8” x 1-1/8” cutout (the inside of the template) from 

the plastic control panel.  Use a Dremel tool (or similar) or drill multiple holes along the edge 
of the template in order to cut away the cutout. 

5.  Remove the template from the control panel. 

6.  Assemble the counter (with mounting plate) to the control panel using the four screws and 

locknuts provided. 

7.  One lead wire from the counter is connected together with the blue wires from the fill 

solenoid valve and the rinse/fill light (using the existing wire nut that connects these two 
wires together). 

8.  The other lead wire from the counter is connected together with the red wires from the fill 

solenoid valve and the rinse/fill light (using the existing wire nut that connects these two 
wires together). 

9.  The counter should increment each time the fill solenoid valve is turned on. 

 

 

Template, Cycle Counter Mount

05700-002-94-37

Cycle Counter Mount

05700-002-94-36

To order the complete Cycle Counter Retrofit Kit with hardware,

use part number 06401-002-95-14.

Instruction Sheet

05700-002-95-15

Cycle Counter, 240V

05990-111-47-42