KitchenAid 5KSM6521X User Manual

Wire whip*

Locating Pin

Spring Latch

Pouring 

Chute

Turn speed control to “0” (OFF), and 

unplug Stand Mixer.

Place bowl lift lever into down position.

Fit bowl supports over locating pins; 

press down on back of the bowl until 

bowl pin snaps into the spring latch. If 

not securely snapped into place, bowl 

will be unstable and wobble during use.

If using the pouring shield*, from the 

front of the Stand Mixer, slide the 

pouring shield over the bowl until it 

is centered. The bottom rim of the 

pouring shield should fit within the bowl.

Slip a beater (flat, wire whip, or dough 

hook) onto the beater shaft and press 

upward as far as possible. Turn beater to 

the right, hooking it over the pin on the 

beater shaft.

NOTE: Rotate the pouring shield* so the 

motor head covers the U-shaped gap in 

the shield. The pouring chute will be just 

to the right of the attachment hub as you 

face the Stand Mixer. 

*  Pouring shield included only for models 5KPM5, 5KSM7580X and 5KSM7591X

Raise the bowl into mixing position 

by rotating the bowl lift lever 

counterclockwise to the straight up 

position. The bowl must always be  

in the raised position when mixing.

W10648168A_ENv03.indd   9

12/11/13   11:48 AM