KitchenAid 5KSM7591X User Manual

NOTE: When properly adjusted, the flat 

beater will not strike on the bottom or 

side of the bowl. If the flat beater or the 

wire whip is so close that it strikes the 

bottom of the bowl, the coating may wear 

off the flat beater (for coated beaters) or 

wires on the wire whip may wear.
Scraping sides of bowl may be necessary 

under certain conditions regardless of 

beater adjustment. The Stand Mixer must 

be stopped to scrape bowl or damage to 

Stand Mixer may occur.

Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the 

bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away from  

the bowl, you can correct the clearance easily.

Lower the bowl to the down position.

Turn beater height adjustment screw (A) 

slightly counterclockwise (left) to raise 

the flat beater; or turn clockwise (right) 

to lower the flat beater. Adjust so that 

the flat beater just clears the surface of 

the bowl. If you over adjust the screw, 

the bowl lift lever may not lock in place.

Turn speed control to “0” (OFF), and 

unplug Stand Mixer.

W10648168A_ENv03.indd   10

12/11/13   11:48 AM