Smeg PTSA727X5 User Manual
Instructions for the Installer
5
2.
Fitting the appliance in the top
The procedures required below must be carried out by a skilled builder and/or joiner.
The hob can be installed on various materials, including masonry, metal, solid wood
The hob can be installed on various materials, including masonry, metal, solid wood
and wood finished with plastic laminates, provided the material is heat-resistant
(T 90° C).
(T 90° C).
2.1 Fixing to the supporting structure
Make a hole in the cabinet top with the dimensions shown here, maintaining a
distance of at least 70 mm from the rear edge. This appliance may be installed
against lateral walls higher than the worktop surface, provided the distance "X" shown
here is maintained, in order to prevent damage due to overheating. Make sure that
there is at least 650 mm between the hob burners and a shelf or hood (if any) placed
vertically above them.
distance of at least 70 mm from the rear edge. This appliance may be installed
against lateral walls higher than the worktop surface, provided the distance "X" shown
here is maintained, in order to prevent damage due to overheating. Make sure that
there is at least 650 mm between the hob burners and a shelf or hood (if any) placed
vertically above them.
(*:
6 Burner Hob, UR2 at Side)
If the hob is installed above a cupboard with doors, a separator panel must be
installed underneath it. Leave a gap of at least 20 mm between the bottom of the hob
and the surface of the panel, which must be easily removable to allow sufficient
access for any servicing procedures.
installed underneath it. Leave a gap of at least 20 mm between the bottom of the hob
and the surface of the panel, which must be easily removable to allow sufficient
access for any servicing procedures.
IMPORTANT: when installing the appliance above a cupboard, a dividing shelf, as
shown above, must be installed.
If installed above an under-bench oven, this is not required.
Installation of an oven without cooking fan underneath the hob is forbidden.
If installed above an under-bench oven, this is not required.
Installation of an oven without cooking fan underneath the hob is forbidden.
Fit the insulating gasket provided carefully around the outside edge of the hole made in
the top as shown below, pressing it down with your hands so that its entire surface fits
snugly. Follow the dimensions shown, depending on the model of hob to be installed,
bearing in mind that on both models the long front edge must be flush with the hole. Fix
the hob to the structure using the brackets A provided. Carefully trim off the excess