Bunn FMD-5 User Manual

10

Product overflows container

Dispenser is making unusual 

noises

Excess dust

Display not lit

1. Dispense Switch

2. Dispense Solenoid Valve

1. Plumbing Lines

2. Water Supply

3. Tank Heater

1. Fan

2. A) Hopper Drive Board - FMD-1

    B) Control board

1. Lamp

2. Lamp Holder

3. Starter - Lamp

4. Ballast

Refer to Service -  Dispense Switch for 

testing procedures. See page 28

Remove the solenoid valve and clear 

any obstructions. Rebuild or replace 

the valve if necessary. See page 47 

Plumbing lines should not be resting 

on the counter top.

(A) The dispenser must be connected 

to a cold water line

(B) Water pressure to the dispenser 

must not exceed 90 psi (620 kPa). 

Install a regulator if necessary to 

lower the working pressure to ap-

proximately 50 psi (345 kPa).

Remove and clean lime off the tank 

heater. See page 50

Refer to Service  - Fan for testing 

procedures. See page 32

Refer to Service - Hopper Drive 

Board for testing procedures. See 

page 35

Refer to Service - Control Board for 

testing procedures. See page 20

Refer to Service -  Lamp, see page 

39 for lamp replacement.

Refer to Service - Lamp Holder for 

testing procedures. See page 39

Refer to Service - Starter for testing 

procedures. See page 40

Refer to Service - Ballast for testing 

procedures. See page 19

42672 122209