Thermador 9000039271 User Manual

NOTE: Make certain that the correct 90° elbow
fitting (not supplied) for the hot water supply line has
been purchased and installed on the dishwasher as
described in the Dishwasher Preparation section of
this manual.

The hot water supply line may be connected to the
dishwasher in one of two ways:

1. With braided hose
2. With copper tubing

After connections are made turn on the hot water
supply to check for leaks.

Temperatures required for soldering

and sweating will damage the dishwasher’s water
inlet valve. If plumbing lines are to be soldered or
sweated, keep the heat source at least 6 inches
(152.4 mm) away from the dishwasher’s water inlet
valve.

•  If using a solder joint instead of a compression

fitting,

 

be sure to make all solder connections

before connecting the water line to the dish-
washer.

•  Make certain there are no sharp bends or kinks in

the water line that might restrict water flow.

•  Be sure to use pipe thread compound or Teflon

tape to seal the connection when required.

•  Before connecting the copper hot water supply

line to the dishwasher, flush it with hot water to
clear any foreign material.

•  Turn on the water supply to check for leaks after

making connections.