Thermador 9000039271 User Manual
4
NOTE: This dishwasher is designed to be enclosed
on the top and both sides by standard residential
kitchen cabinetry.
on the top and both sides by standard residential
kitchen cabinetry.
Select a location as close to the sink as possible for
easy access to water supply and drain lines.
For proper dishwasher operation and appearance,
ensure that the enclosure is square and has the
dimensions shown in Figure 2.
If the dishwasher is to be installed in a corner, make
sure that there is adequate clearance to open the
door, as shown in Figure 3, letter A.
easy access to water supply and drain lines.
For proper dishwasher operation and appearance,
ensure that the enclosure is square and has the
dimensions shown in Figure 2.
If the dishwasher is to be installed in a corner, make
sure that there is adequate clearance to open the
door, as shown in Figure 3, letter A.
WARNING: ELECTRICAL SHOCK/FIRE
HAZARD - Do not allow the electrical and
water supply lines to touch. Separate
channels are provided under the
dishwasher (see page 10).
water supply lines to touch. Separate
channels are provided under the
dishwasher (see page 10).
If the enclosure requires openings for the electrical
supply cable, hot water supply line, and dishwasher
drain hose, place them within the dimensions
shown by the shaded area of Figure 4 to avoid
interference with the dishwasher frame or other
components. Make the openings for the electrical
supply cable and hot water supply line 1” (25.4mm)
diameter. Make the opening for the dishwasher drain
hose 1-1/4” (32mm) diameter. If the openings are
made through wood, sand them smooth. If the
openings are made through metal, make them large
enough to accommodate grommets or other
protective sheaths with inside diameters of 1”
(25.4mm) for the electrical supply cable and the hot
water supply line, and 1-1/4” (32mm) for the dish-
washer drain hose.
supply cable, hot water supply line, and dishwasher
drain hose, place them within the dimensions
shown by the shaded area of Figure 4 to avoid
interference with the dishwasher frame or other
components. Make the openings for the electrical
supply cable and hot water supply line 1” (25.4mm)
diameter. Make the opening for the dishwasher drain
hose 1-1/4” (32mm) diameter. If the openings are
made through wood, sand them smooth. If the
openings are made through metal, make them large
enough to accommodate grommets or other
protective sheaths with inside diameters of 1”
(25.4mm) for the electrical supply cable and the hot
water supply line, and 1-1/4” (32mm) for the dish-
washer drain hose.
Figure 2
23-5/8" – 24-1/4" (600–616 mm)
34"
(864mm)
minimum
23-9/16"
(598mm)
90
°
90
°
A
Figure 3
Countertop
Figure 4
3-1/2"
(89mm)
1-5/16"
(33mm)
23-5/8" – 24-1/8"
(600mm – 613mm)
ENCLOSURE PREPARATION