Thermador Dishwasher User Manual
Delay start
You can delay the start of the program in 1-hour steps up to 24 hours.
You can delay the start of the program in 1-hour steps up to 24 hours.
Open the door
•
(for hidden controls only). Turn unit on using the ON/OFF button.
Press “
•
+
” button until the timer programming display jumps to 01 .
Press + or – button until the displayed time corresponds with your requirements.
•
Press START button. Delay start is activated.
•
To cancel delay start:
Press the + or – button until “00” is indicated on the digital display.
•
You can change your program selection at any time until the program starts.
You can change your program selection at any time until the program starts.
Close the door
•
(for hidden controls only).
Cycle Completion Signal
The cycle completion is also indicated by a tone.This function can be changed as
The cycle completion is also indicated by a tone.This function can be changed as
follows:
Open the door
•
(for hidden controls only). Turn unit on using the ON/OFF button.
Hold down [
•
A
] button and press START button until the display shows H:00.
Release both buttons.
•
Press [
•
A
] until the display shows “
b:02”.
Press [
•
C] to increase or decrease the tone.
b:00
•
= Off and
b:03 = loudest
Press
•
START to save the setting.
Intensive drying
The inal rinse uses a higher temperature which improves the drying result.
The running time may increase slightly. (Caution if utensils are delicate!)
The running time may increase slightly. (Caution if utensils are delicate!)
Open the door.
•
(for hidden controls only). Turn unit on using the ON/OFF button.
Hold down [A
] button and press START the digital display shows “H:00”.
Release both buttons.
•
Press button [A] until the display indicates “d:00”
•
To change the setting,
To change the setting,
Press button [C] (see page 4) to turn intensive drying ON = d:01 or OFF = d:00
•
Press START button. The set value is saved.
•
Close the door
•
(for hidden controls only).
Interrupting the cycle
Open the door
•
(for hidden controls only).
Press the ON/OFF button. The LEDs go out. The program is saved. If the door
•
was opened on an appliance which has a warm water connection or is heated,
irst leave the door ajar for several minutes and then close. Otherwise, expansion
(pressure) may cause the appliance door to spring open or water to run out of the
appliance.
To continue the program, switch on the ON/OFF switch again.
(pressure) may cause the appliance door to spring open or water to run out of the
appliance.
To continue the program, switch on the ON/OFF switch again.
•
Close the door.
•
(for hidden controls only)
Operating the Unit
Switching on the appliance
Open the door
•
(for hidden controls only).
Turn unit on by pressing the ON/OFF switch. The display of the last
•
selected program lashes.
The expected program duration lashes on the digital display.
•
Press the START button.
•
Close the door (for hidden controls only). The program starts running.
•
15