321 Studios 8400 Series User Manual
92
Removing and Installing Parts
www
.dell.com | support.dell.com
Installing a Hard Drive
1
Unpack the replacement hard drive, and prepare it for installation.
2
Check the documentation for the drive to verify that it is configured for your computer.
3
If your replacement hard drive does not have the bracket rails attached, remove the rails from
the old drive by removing the two screws that secure each rail to the drive. Attach the bracket
rails to the new drive by aligning the screw holes on the drive with the screw holes on the
bracket rails and then inserting and tightening all four screws (two screws on each rail).
the old drive by removing the two screws that secure each rail to the drive. Attach the bracket
rails to the new drive by aligning the screw holes on the drive with the screw holes on the
bracket rails and then inserting and tightening all four screws (two screws on each rail).
4
Install the hard drive into the computer by gently sliding the drive into place until you hear it
securely click.
securely click.
5
Connect the power and data cable to the drive and to the system board (see page 71).
drive
screws (4)
bracket rails (2)