Jura Capresso ENA 5 User Manual

1.   Push and hold the P button (Fig. 4) until the display shows 

.

2. Turn the Rotary Dial until the display shows 

.

3. Push the Rotary Dial. The display shows 

.

4. Push the Rotary Dial again. The display shows 

.

5. Turn the Rotary Dial until the display shows 

.

6. Push the Rotary Dial to confirm. The display shows 

and 

then 

. You have now set the coffee volume for 1 CUP

to 3 oz. Note: when using the 2-cup setting the ENA will now
produce a total of 6 oz.

7. Turn the Rotary Dial to 

and push the 

Rotary Dial. The display shows 

.

8. Turn the Rotary Dial until the display shows 

and

push the Rotary Dial to confirm. The display shows 

and 

then 

.

9. Turn the Rotary Dial until the display shows 

.

10. Push the Rotary Dial. The display shows 

.

11. Turn the Rotary Dial until the display shows 

and 

push to confirm. The display shows 

and then 

.

You have now re-programmed all three settings.

12. Push the P button to return to 

.

14b. VISUAL PROGRAMMING OF CUP SIZE
You can also reprogram the cup size visually. 

.

• Place the cup underneath the coffee spout.
• Press and hold down the Rotary Dial until the display reads 

Then let go. The ENA starts grinding and 

brewing coffee.

• When the desired amount of coffee is in your cup push the 

Rotary Dial again. The display shows 

and then 

. 

This is now the new programmed volume for the one cup size.

15. WATER CARE
Water is heated inside the machine, this leads to calcium
deposits forming. The ENA works with:
• regular tap water • bottled water • distilled water.
We recommend using regular tap water or bottled water. Distilled
water has no minerals and does not improve the taste of coffee.
Tap water has a varying degree of water hardness (chapter 16).
Most bottled water has a low level of water hardness.
IMPORTANT: do not use carbonated water or any other liquid in
the water tank.
You have the following options to take care of the water.
• Decalcifying System (chapter 18.3).
• Clearyl Water Filter Cartridge (chapter 17.1).
Your machine is pre-set in the factory to automatically remind
you to decalcify. You can change the water hardness setting to
comply with the water you are using (chapter 16.1).
Please note: The machine will automatically remind you when it
is necessary to run certain water maintenance programs. It is
important that you follow those instructions. Otherwise your
machine may not function properly.

16. WATER HARDNESS MONITOR
Your ENA is set to a water hardness of 10ºdH. The ENA will
remind you when it is time to perform a decalcifying cycle. You
can change the water hardness setting from 1 to 30dH. If you
are not sure about the hardness of your water, ask your local
water company for the "Water Hardness in Grains." The machine
displays the water hardness in the German hardness scale which
is a bit different from the American "Grain" scale (see chart
below). You can also use the enclosed water hardness indicator

21.