Jura Capresso ENA 5 User Manual

25.

.

9. Remove the cup and then the drawer and tray.
10. Empty drawer and ground coffee container and replace.
11. The display shows 

.

The machine will automatically remind you after the next 180
cups of coffee to repeat this cycle.

18.2 MANUAL TABLET CLEANING CYCLE
It is possible that the brewing process slows down before the
automatic message (chapter 18.1) appears. Dark beans may
deposit more oils into the brewing chamber. When this happens
you can manually start a tablet cleaning cycle as follows:

• Push and hold the P button (Fig. 4) until display shows 

.

• Push the P button again. The display shows again 

.

• Turn the Rotary Dial until the display shows 

.

• Push the Rotary Dial 

Continue with steps 2 through 11 in chapter 18.1

18.3 DECALCIFYING 
The ENA has an integrated decalcifying program. This decalcify-
ing program takes about 40 minutes. Your ENA is set in the fac-
tory to automatically remind you when it is time to decalcify the
machine. If you do not use the Clearyl filter, we recommend that
you purchase one set of Jura decalcifying tablets (one set is
good for three decalcifying procedures). See chapter 31.
Please note: If you have installed and activated the Clearyl filter,
the decalcifying program is inactive.
DECALCIFYING AGENT: Only use our special decalcifying
tablets Model # 66281, chapter 31.

CAUTION: 
• Avoid contact of the descaling agent with the skin or eyes. 

This can cause irritation. Rinse the descaling agent off with 
clear, clean water. Should you get descaling agent in your 
eyes, consult a doctor.

• Immediately remove any splashes or drops of the decalcifying 

agent from sensitive surfaces, such as natural stone or wood. 

• Always wait until the decalcifying agent in the water tank has 

been used up. Do not fill additional decalcifying agent into 
the water tank.

• Never use vinegar or any other decalcifying agent. This might 

damage internal parts of the machine.

When the display shows 

/ 

it is time to

decalcify the machine. You can still make coffee. However, it is
highly recommended decalcifying the machine within the next 3
to 4 days.
Important: CLEARYL FILTER: If you use the Clearyl water
cartridge and the display shows 

/ 

, then your

cartridge function was not activated. Follow the instructions in
chapter 17.1 to activate a new cartridge.
Important: The decalcifying program must not be interrupted.

/ 

1. Remove the Dual Frother or the frothXpress from the steam 

nozzle (Fig. 17).

2. Open the cover behind the Rotary Dial and press the Rinse 

button (Fig. 4) The display shows 

.

3. Remove the complete drawer with the grid and the used 

coffee container (Fig. 1, 12 to 14) and empty the tray and the
used coffee container.