Bunn CDS-3 User Manual

40

FIG. 33 FUSE HOLDER

P1342

Location:

The fuse holder is located inside the dispenser on 

the upper left side of the component bracket just below 

the circuit breaker.
Test Procedures:

1.   Disconnect the dispenser from the power source.

2.  Remove cap and fuse from fuse holder.

3.  Remove fuse from the cap.

4.  Check for continuity through the fuse.
If continuity is present as described, reinstall the fuse, 

the fuse is operating properly.
If  continuity  is  not  present  as  described,  replace 

fuse.
Removal and Replacement:
Fuse:

1.  Remove the cap from the fuse holder.

2.  Remove fuse from the fuse holder, inspect, if blown 

discard.

3.  Install new 5 amp fuse in the fuse holder

4.  Reinstall fuse holder cap.

FIG. 34 FUSE HOLDER TERMINALS

P1331

Fuse Holder:

1.  Disconnect  the  wires  from  the  rear  of  the  fuse 

holder.

2.  Remove nut securing the fuse holder to the com-

ponent bracket.

3.  Push fuse holder through the hole in the component 

bracket.

4.  Install new fuse holder and fuse through the hole 

in the component bracket.

5.  Secure the fuse holder to the component bracket.

6.  Refer to Fig. 34 and reconnect the wires.

27646 022500

WHI/GRN from Main 

Harness/ON/OFF 

Switch

WHI/GRN from Main 

Harness/Control Board