Bunn BTC User Manual

Page of 12
6
OFF
O
N
OFF
PREPARING THE BREWER FOR USE
NOTE - THE BREWER IS NOT READY TO PLUG IN.
Do NOT plug in until Step #3.
OFF
O
N
OFF
  Raise the hinged flip-lid. 
  NOTE: The post protruding from the screen is con-
nected  to  a  stopper  that  controls  the  flow  of  water 
into the tank.  When lid is closed (post depressed), the 
stopper is raised and water will flow into the tank.
 
Plug in the brewer.
Step 2
  Slide an empty brew funnel into the brewer.  Pour one 
carafe full of water into the screened area on top of the 
brewer (there is no need to have the lid on the carafe at 
this time). Place carafe in position on the brewer. Close 
lid. Wait three minutes to allow the water to flow into 
the  tank.  Repeat  this  process. When  the  tank  is  full, 
some water will flow through the funnel and into the 
carafe. Leave the carafe in place.
P2559
P2561
P214
P2560
Step 4
  Press the bottom of the vacation switch, located on 
the lower left side of the brewer, to the “ON” (lower) 
position.   The  vacation  switch  controls  power  to  the 
tank heater.  Initially you will have to wait approximately 
fifteen  minutes  in  order  for  the  water  to  reach  brew 
temperature.
Empty any water that has collected in the carafe.  
The next page leads you through the five easy steps to 
‘BREWING DELICIOUS COFFEE’
OFF
O
N
OFF
Step 1
Step 3