Desa CGESBMRA User Manual

Page of 12
www.desatech.com
119668-01A
6
CLEANING AND 
MAINTENANCE
  WARNING: Always  discon-
nect power and allow the heater 
to  cool  before  performing  any 
cleaning, maintenance or reloca-
tion of this heater. Turn controls 
to  OFF  and  remove  plug  from 
outlet or turn off circuit breaker 
to heater.
Turn off heater and circuit breaker to heater before 
performing any cleaning and/or maintenance. Al-
low heater to cool completely.
bUlb RePlACeMeNT
 WARNING: The halogen light 
bulbs  in  your  unit  can  become 
extremely hot. Allow at least 10 
minutes between turning off the 
heater  and  removing  the  light 
bulbs to avoid accidental burns.
There are a total of 5 ( halogen light bulbs (type 
GX6.35 rated 120 volts, 35 watts) in your unit.
•  1 bulb provides illumination for the ember bed 
beneath the log set 
•  2  bulbs  provide  illumination  for  the  flame 
generation assembly
•  2 bulbs for replacement
Most halogen light bulbs are rated to last approxi-
mately 1800 hours. Like all light bulbs, halogen 
bulbs require periodic replacement. When the 
bulbs in your unit have burned out you will notice 
one or more of the following:
•  Flame is dim or dark in certain areas
•  Log set ember bed appears dim or dark in 
certain areas
  WARNING:  Do  not  install 
replacement bulbs that exceed 
specified maximum watts.
Your unit must be opened from the back in order 
to replace the flame generation bulbs. To replace 
the bulb under the ember bed you will open the 
unit in front. 
Replacing log Set ember bed bulb
1.  Turn knob and open door of stove.
2.  Push in and up on lower front panel. The panel 
slides into notches on front sides of stove as 
shown in Figure 5.
3.  Remove two screws securing grate. Remove 
grate.
4.  Hold log up away from bulb and carefully 
remove spring clip over bulb using needle 
nose pliers. Remove bulb.
5.  With log being held up away from socket, 
insert new bulb and carefully replace spring 
clip using needle nose pliers.
Replacing Flame Generation bulbs
1.  Unscrew  4  screws  from  louvered  back 
panel (see Figure 6). Remove louvered back 
panel.
Figure 5 - Ember Bed Bulb Location
Grate
Lower Front 
Panel
Bulb in Socket 
with Spring Clip
Log
Louvered 
Back 
Panel
Lower 
Back 
Panel
Figure 6 - Back of Stove
Back 
Control 
Panel