Jonsered FC 2255W Service Manual

English

 – 21

Use the same starting procedure as for a cold engine but 
without setting the choke control in the choke position.

Start throttle: (FC2255, FC2255W, BC2255)

Set the throttle to the start position by moving the choke 
control to the choke position and then returning it to its original 
position.

Start throttle: (BC2255)

Set the throttle to the start position by first pressing the throttle 
lockout and the throttle trigger, then pressing the start throttle 
button (A). Then release the throttle lockout and the throttle 
trigger, followed by the start throttle button. The throttle 
function is now activated. To return the engine to idle, press 
the throttle lockout and throttle trigger again.

Hold the body of the machine on the ground using your left 
hand (CAUTION! Not with your foot!). Grip the starter handle, 
slowly pull out the cord with your right hand until you feel 
some resistance (the starter pawls grip), now quickly and 
powerfully pull the cord. Never wrap the starter cord around 
your hand

Repeat pulling the cord until the engine starts. When the 
engine starts. return choke control to run position and apply 
full throttle; the throttle will automatically disengage from the 
start setting.

CAUTION!  Do not pull the starter cord all the way out and do 
not let go of the starter handle when the cord is fully extended. 
This can damage the machine.

Stop the engine by switching off the ignition.

Models equipped with heating elements in the handles have 
an on/off switch on the throttle handle to control the heat. Both 
the left and right handles have heating elements that 
automatically maintain a temperature of roughly 70

° when the 

heat is turned on.