Thermador PH36HS User Manual

Page of 60
English 1
Safety
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
APPROVED FOR ALL RESIDENTIAL APPLIANCES
FOR RESIDENTIAL USE ONLY
Before You Begin
IMPORTANT: Save these Instructions for the Local Gas 
Inspector’s use.
INSTALLER: Please leave these Instructions with this unit 
for the owner.
OWNER: Please retain these instructions for future 
reference.
Safety Codes and Standards
This appliance complies with the following Standards:
UL 507, Standard for the Safety of Electrical Fans
CAN/CSA-C22.2 No. 113, Fans and Ventilators
It is the responsibility of the owner and installer to 
determine if additional requirements and/or standards 
apply to specific installations. Always refer to local codes to 
ensure all requirements are met. 
If required by the National Electrical Code (or Canadian 
Electrical Code), this appliance must be installed on a 
separate branch circuit.
INSTALLER — show the owner the location of the circuit 
breaker or fuse. Mark it for easy reference.
Never modify or alter the construction of the appliance. For 
example, do not remove panels or wire covers.
WARNING: 
If the information in this manual is not followed exactly, 
fire or shock may result causing property damage or 
personal injury.
Do not repair or replace any part of the appliance unless 
specifically recommended in the manuals. Improper 
installation, service or maintenance can cause injury or 
property damage or void product warranty. Refer to this 
manual for guidance. All other servicing should be done 
by a qualified technician.
CAUTION: 
The unit is heavy and should be handled 
accordingly. Proper safety equipment such 
as gloves and adequate manpower of at 
least two people must be used in moving the 
hood to avoid injury and to avoid damage to 
the unit or the floor. Rings, watches, and any 
other loose items that may damage the unit 
or otherwise might become entangled with 
the unit should be removed. 
Hidden surfaces may have sharp edges. 
Use caution when reaching behind or under 
appliance.
WARNING: 
Turn off power circuit at service panel and lock out panel 
before wiring this appliance. Requirement: 120 VAC, 60 
Hz 20 A. Allow the appliance to cool after the power has 
been turned off before servicing the appliance.
WARNING: 
To reduce the risk of fire use only metal ductwork.
CAUTION:
 
Vent unit to the outside of building only. This unit is only 
designed to be vented outside. It should not be used for 
recirculation mode.