Graco 310554V User Manual

To install the control assembly:

•

Prepare to install the control assembly 

•

Mount the control assembly 

•

Ground the control assembly (electrically)

•

Connect control assembly to a power source 

•

Check resistance between the control assembly and 
a true earth ground.

Before installing the control assembly:

•

See component manuals for specific data on com-
ponent requirements, such as a robot. Data pre-
sented here pertains to the PrecisionSwirl control 
assembly only.

•

Have all applicable documentation available during 
installation.

•

Use only the Graco PrecisionSwirl control assembly 
with the PrecisionSwirl applicator.

1.

Select a location to mount the PrecisionSwirl control 
assembly. Keep the following in mind:

Allow sufficient space for mounting and using the equip-
ment: 

•

Mount the control assembly approximately 24-67 in. 
(0.6-1.7 m) above the floor.

•

Make sure all cables reach components without 
strain.

•

Make sure there is sufficient space for repair, main-
tenance, and operation of the robot and applicator. 
The National Electrical Code requires 3 ft (91.4 cm) 
of open space in front of the control assembly.

•

Make sure there is sufficient clearance around the 
control assembly for running fluid lines and cables to 
other components. 

•

Make sure there is easy and safe access to an 
appropriate electrical power source. 

2.

Secure the PrecisionSwirl control assembly with 
four 1/4 in. bolts through the 0.31 in. diameter holes 
in the mounting flanges. See F

. 4 for the mounting 

hole spacing in the control assembly.

Installing and servicing this equipment requires access 
to parts which could cause an electric shock or other 
serious injury. Have only qualified electricians access 
the control assembly.

The PrecisionSwirl control assembly weighs approxi-
mately 23.5 lb (10.7 kg). Exercise care when mounting 
and handling the control assembly to prevent equip-
ment damage or personal injury.