Jenn-Air 2300279C User Manual

After you remove all of the package materials, clean the inside of 
your refrigerator before using it. See the cleaning instructions in 
“Refrigerator Care.”

IMPORTANT: 

■

Create custom overlay panel according to the specifications in 
the “Custom Overlay Panel” section.

■

Jenn-Air is not responsible for the removal or addition of 
molding or decorative panels that would not allow access to 
the refrigerator for service.

IMPORTANT: Do not remove the grease from the washer, top 
spacer or top hinge pin. Be sure to set aside the top hinge, top 
spacer and washer for later use.
1. Using a Phillips screwdriver, remove the three screws from the 

top hinge. Remove the top hinge.

2. Remove the three screws from the top spacer. Remove the 

top spacer and washer.

3. Open the door. Lift the front of the door up, pulling straight out 

to remove as shown.

NOTE: If the overlay hooks are not installed, see “Custom Overlay 
Panel” for overlay hook locations.
1. Position the overlay panel 

¹⁄₂" (1.27 cm) higher than the door. 

Be sure to position the overlay hooks to the pilot holes. 

2. Insert the overlay hooks into the top of the holes in the door. 

Push against the overlay panel to force the overlay hooks 
deeper into the door. Pull the overlay panel straight down to 
secure the overlay hooks to the door.

3. Using a Phillips screwdriver, attach the overlay plates to the 

bottom of the overlay panel and door as shown.

Do not clean glass shelves or covers with warm water when 
they are cold. Shelves and covers may break if exposed to 
sudden temperature changes or impact, such as bumping. 
Tempered glass is designed to shatter into many small, 
pebble-size pieces. This is normal. Glass shelves and covers 
are heavy. Use both hands when removing them to avoid 
dropping.