KitchenAid 12642708SP User Manual

■

Remove tape and glue residue from surfaces before turning 
on the refrigerator. Rub a small amount of liquid dish soap 
over the adhesive with your fingers. Wipe with warm water 
and dry.

■

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your refrigerator. For 
more information, see the “Refrigerator Safety” section.

■

On some models, shelves, bins, door shelf rails, and other 
feature parts may be packaged in the Interior FeaturePak. 
Follow the instructions contained in the package for proper 
assembly.

■

Depending on your model, to remove the protective 
(transparent) film that is on the nameplate, which is located 
on the freezer handle, use your fingernail and peel off the film, 
starting from one side and peeling to the other.

IMPORTANT: Do not remove the white foam air return insert that 
is located behind the control panel on the ceiling of the 
refrigerator (on some models). The insert is part of the refrigerator 
and not part of the packing material. If the insert is removed, ice 
may migrate down from the freezer and cause icicles to form.

After you remove all of the package materials, clean the inside of 
your refrigerator before using it. See the cleaning instructions in 
the “Refrigerator Care” section.

■

To ensure proper ventilation for your refrigerator, allow 

¹⁄₂ in. 

(1.25 cm) space at the top and back and 

³⁄₁₆ in. (0.48 cm) on 

each side of the refrigerator for ease of installation.

■

If you are installing your refrigerator next to a fixed wall, leave 
2

¹⁄₈ in. (5.4 cm) minimum on each side (depending on your 

model) to allow for the door to swing open.

■

If your refrigerator has an ice maker, make sure you leave 
some extra space at the back for the water line connections.

NOTE: Do not install the refrigerator near an oven, radiator, or 
other heat source, nor in a location where the temperature will fall 
below 55°F (13°C).

Your refrigerator is heavy. When moving the refrigerator 
for cleaning or service, be sure to protect the floor. 
Always pull the refrigerator straight out when moving it. 
Do not wiggle or “walk” the refrigerator when trying to move 
it, as floor damage could occur.

Do not clean glass shelves or covers with warm water when 
they are cold. Shelves and covers may break if exposed to 
sudden temperature changes or impact, such as bumping. 
For your protection, tempered glass is designed to shatter 
into many small, pebble-size pieces. This is normal. Glass 
shelves and covers are heavy. Use special care when re-
moving them to avoid impact from dropping.