U-Line 2015WC User Manual

www.U-LineService.com

02/2005

1. Locate two Anti-Tip Brackets included inside the unit.

2. Place the unit into the area where it will be installed. 

Check the door, sides and top for a proper fit. Also test 
to make sure the door opens and closes freely.

3. Remove grill and place a mark on the floor at the front 

of the unit. Also place a mark on the floor in the center 
of the unit. See Figure 30.

4. Remove the unit. Using a square, extend a centerline 

20-1/4" toward the back wall. See Figure 31. At the 
back of the centerline, mark a line that measures 
6-9/16" to the left and right. This line serves as the back 
edge for the Anti-Tip Brackets and its furthest points 
mark the outer edge of each bracket.

Note: Instructions are shown for built-in installation. Use 
same dimensions for free-standing installation.

5. Place the Anti-Tip Brackets on the floor against the line 

drawn for the outer edge. Mark spots for the screw 
holes. See Figure 32.

6. Use a 1/8" drill to make two starter holes and fasten the 

Anti-Tip Brackets to the floor using the screws provided.

Other hardware is required for floors made of materials 
other than wood.

7. Place the unit back into position, making sure the feet 

engage the Anti-Tip Brackets properly. Check the 
alignment of the lines made on the floor in Step 3 with 
the position of the front feet to ensure proper 
positioning.

Marks on Floor

20-1/4"

6-9/16"

6-9/16"

Back

Wall

Centerline

Marks

on Floor

Line Marks

Back

of Unit

Front

of Unit

Back

Wall

Back

of Unit

Drill Holes and

Mount Anti-Tip

Brackets to Floor

Front

of Unit