Viking F20497 User Manual
24” W. Models
15” W. Models
3
A
B
C
UNDERCOUNTER CABINET CUTOUT
*Add 1/4” (.64 cm) to cutout width if door is recessed between
cabinets.
IMPORTANT - PLEASE READ AND FOLLOW
•
• Before beginning, please read these instructions completely and carefully.
• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• Please ensure that this product is properly grounded.
• The installer should leave these instructions with the consumer who should retain for local inspector’s use and for
• Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
• Please observe all local and national codes and ordinances.
• Please ensure that this product is properly grounded.
• The installer should leave these instructions with the consumer who should retain for local inspector’s use and for
future reference.
WARNING
::
T
To
o rre
ed
du
ucce
e tth
he
e rriisskk o
off ffiirre
e,, e
elle
eccttrriicca
all ssh
ho
occkk,, o
orr iin
njju
urryy w
wh
he
en
n u
ussiin
ng
g yyo
ou
urr rre
effrriig
ge
erra
atte
ed
d b
be
evve
erra
ag
ge
e cce
en
ntte
err,, ffo
ollllo
ow
w b
ba
assiicc
p
prre
ecca
au
uttiio
on
nss iin
nccllu
ud
diin
ng
g tth
he
e ffo
ollllo
ow
wiin
ng
g::
•FOR YOUR SAFETY•
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR
ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.
ANY OTHER APPLIANCE. THE FUMES CAN CREATE A FIRE HAZARD OR EXPLOSION.
IItt iiss yyo
ou
urr rre
essp
po
on
nssiib
biilliittyy tto
o b
be
e ssu
urre
e yyo
ou
urr rre
effrriig
ge
erra
atte
ed
d b
be
evve
erra
ag
ge
e cce
en
ntte
err iiss::
•located so the front is not blocked to restrict incoming or discharge air flow.
•properly leveled.
•located in a well ventilated area.
•connected to the proper kind of outlet, with the correct electric supply and grounding. A 115 volt, 60 Hz, 15 amp
•properly leveled.
•located in a well ventilated area.
•connected to the proper kind of outlet, with the correct electric supply and grounding. A 115 volt, 60 Hz, 15 amp
fused electrical supply is required. N
NO
OT
TE
E:: Time delay fuse or circuit breaker is recommended.
•not used by anyone unable to operate it properly.
•used only for its intended purpose.
•properly maintained.
•used only for its intended purpose.
•properly maintained.
•SAVE THESE INSTRUCTIONS•
IMPORTANT: Child entrapment and suffocation are not problems of the
past. Junked or abandoned refrigerated beverage centers are still
dangerous, even if they will sit for “just a few days.” If you are getting rid
of your refrigerated beverage center, please follow the instructions below
to help prevent accidents.
past. Junked or abandoned refrigerated beverage centers are still
dangerous, even if they will sit for “just a few days.” If you are getting rid
of your refrigerated beverage center, please follow the instructions below
to help prevent accidents.
BEFORE YOU THROW AWAY YOUR OLD REFRIGERATION PRODUCT:
•Take off the doors.
•Leave the shelves in place so that children may not easily climb inside.
•Take off the doors.
•Leave the shelves in place so that children may not easily climb inside.
PROPER DISPOSAL OF YOUR OLD REFRIGERATION PRODUCT
2
A
15” (38.1 cm)*
24” (61.0 cm)*
B
Min. 34 1/2” (87.6 cm)
Max. 35 1/8” (89.2 cm)
Min. 34 1/2” (87.6 cm)
Max. 35 1/8” (89.2 cm)
C
24” (61.0 cm)
24” (61.0 cm)
SUFFOCATION HAZARD
Remove doors from your old refrigeration unit.
Failure to do so can result in child entrapment,
which can cause death or brain damage.
Failure to do so can result in child entrapment,
which can cause death or brain damage.
DANGER
AREA REQUIREMENTS
U
Un
niittss C
Ce
errttiiffiie
ed
d ffo
orr IIn
nd
do
oo
orr U
Usse
e -- ((b
blla
acckk o
ou
utte
err cca
ab
biin
ne
ett))
MUST BE INSTALLED IN AN AREA PROTECTED FROM THE ELEMENTS, SUCH AS WIND, RAIN, WATER (SPRAY OR
DRIP).
1. Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in
DRIP).
1. Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in
on the top and three sides, but the front M
MU
US
ST
T B
BE
E unobstructed for air circulation and proper operation.
Installation should be such that the cabinet can be moved for servicing if necessary.
2. Unit should be in a well ventilated area with temperature above 55°F (13°C) and below 110°F (43°C). Best results
are obtained at temperatures between 65°F (18°C) and 80°F (27°C) for built-in products and 65°F (18°C) and 90°F
(32°C) for freestanding products.
(32°C) for freestanding products.
3. Provisions for electricity should be determined before placing unit in proper place.
U
Un
niittss C
Ce
errttiiffiie
ed
d ffo
orr O
Ou
uttd
do
oo
orr U
Usse
e -- ((sstta
aiin
nlle
essss sstte
ee
ell o
ou
utte
err cca
ab
biin
ne
ett))
1. Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in
on the top and three sides, but the front M
MU
US
ST
T B
BE
E unobstructed for air circulation and proper operation.
Installation should be such that the cabinet can be moved for servicing if necessary.
2. Unit should be in a well ventilated area with temperature above 40°F (4.4°C) and below 110°F (43°C). Best results
are obtained at temperatures between 60°F (16°C) and 100°F (38°C).
3. Provisions for electricity should be determined before placing unit in proper place.
GENERAL INFORMATION
U
Un
np
pa
acckk
1. Remove banding from bottom of carton. Lift carton up and off of the unit.
2. Remove all tape and packaging material from the outside and inside of the cabinet.
3. Keep all carton packaging until your refrigerated beverage center has been thoroughly inspected and found to be in
2. Remove all tape and packaging material from the outside and inside of the cabinet.
3. Keep all carton packaging until your refrigerated beverage center has been thoroughly inspected and found to be in
good condition.