Viking phk30 professional series handle kit User Manual
IMPORTANT–
Please Read and Follow!
2
3
•
Before beginning, please read these instructions completely and carefully.
•
Use caution during assembly to minimize scratches.
•
Do not remove permanently affixed labels, warnings or plates from the product. This may
void the warranty.
void the warranty.
•
Please refer to the product Installation Instructions for more information on installing the
door panel.
door panel.
•
The installer should leave instructions with the customer who should retain for local
inspector’s use and future reference.
inspector’s use and future reference.
Parts Included
Part
Quantity
Professional Series Handle Tube
Professional Series End Caps
1/4” x 1” Phillips Head Screws
Installation Instructions
Required Tools
Electric Drill
5/16” (.8 cm) Drill Bit
5/8” (1.6 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Phillips Head Screwdriver
Masking Tape and Pencil
Rubber Mallet
5/16” (.8 cm) Drill Bit
5/8” (1.6 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Phillips Head Screwdriver
Masking Tape and Pencil
Rubber Mallet
To Install:
Installation with Wooden Full Overlay
Custom Door Front
Custom Door Front
(1)
(2)
(4)
1. Locate the wooden custom panel.
2. Using the illustrations on the next page, layout the handle location on the panels. It is
2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the four holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.
the hole placement and to prevent any damage to the door when drilling the holes.
3. The Professional handle will be mounted using (4) of the 1/4” x 1” Phillips head screws
provided. Using the 5/16”(.8 cm) drill bit, drill completely through the door in the hole
locations. Using the 5/8” (1.6 cm) bit, counter-bore two holes 1/4” (.6 cm) deep on the
BACKSIDE of the custom door panel.
locations. Using the 5/8” (1.6 cm) bit, counter-bore two holes 1/4” (.6 cm) deep on the
BACKSIDE of the custom door panel.
4. Place a handle end cap on both ends of the handle tube. Tap the endcaps firmly into place
with a rubber mallet ensuring that both endcaps mounting surfaces are parallel.
5. Align the holes in the endcaps with the holes on the panel and attach the Professional
handle to the panel using the (4) 1/4” (.6cm) screws provided.
Handle Installation -
FRCI/FBCI/FWCI Undercounter Refrigeration
5/8” (1.6 cm) Ø x 1/4” (0.6 cm) counterbore
1-3/8” (3.5 cm)
5/16” (0.8 cm) Ø through-holes
3/4” (1.8 cm)
Full Overlay Panel
Full Overlay Panel
Section A-A
Professional Series Handle
29-1/16”
(73.8 cm)
A
A
5/16” (0.8 cm) through-holes
with 5/8” x 1/4” counterbore
*See section A-A.
5/8”
(1.6 cm)
9/16”
(1.4 cm)
1-3/8”
(3.5 cm)
TYP