Danby D1866WE User Manual

•  Remove tape and any labels from your refrigerator
before using (except the model and serial number label).
Do not remove any permanent instruction labels.

To remove any remaining tape or glue, rub the area
briskly with your thumb.  Tape or glue residue can also
be easily removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers.  Wipe with
warm water and dry.

•  Do not use sharp instruments, rubbing alcohol, flam-
mable fluids, or abrasive cleaners to remove tape or
glue.  These products can damage the surface of your
refrigerator.  For more information, see “Important Safety
Instructions” in the “Refrigerator Safety” section.

•  Do not install the refrigerator near an oven, radiator,
or other heat source, not in a location where the
temperature will fall below 40°F (5°C).

Note:  Some shelf trim comes with a protective
film.  Look for the “Peel Off” strip to remove this
protective film.

Unpacking Your Refrigerator

WARNING

•  To ensure proper ventilation for your refrigerator, allow for a
1” (2.5 cm) space on each side.

•  Allow 3”” (7.5 cm) of space between overhead cabinets
and refrigerator top.

•  Allow at least 1” (2.5 cm) between back of cabinet and the
wall.

•  If the hinge side of the refrigerator is to be against a wall,
you might want to leave extra space so the door
can swing open.

Space Requirements

WARNING