Smeg GCS70XG User Manual

 

 

 

   

 

 Make sure that the voltage and capacity of the power line conform to 

the data shown on the plate located under the casing. Do not remove 
this plate for any reason. 

 

   

 

  The plug on the end of the supply cable and the wall socket must be the 

same type and conform to the current electrical system regulations. 
Check that the power line is adequately grounded. 

 

   

 

  On the power line, install an omnipolar cut-off device with contact cut-off 

distance greater than or equal to 3 mm, located in an easily accessible 
position near the unit. 

 

   

 

  Do not use reducers, adapters or shunts. 

 

   

 

  If the power cable is replaced, the wire section on the new cable must 

not be less than 1.0 mm 

2

 

(3 x 1.0 cable), keeping in mind that the end 

to 
be connected to the hob must have the ground wire (yellow-green) 
longer by at least 20 mm. Use only H05V2V2-F cable or similar which 
has a maximum temperature of 90°C. Any replacement needed should 
be carried out by a specialised technician who should make the mains 
connections according to the following diagram. 
L = brown 
N = blue 

= yellow-green 

 

   

 

 

 

 

   

 

  The manufacturer will not be liable for any damage to persons or