Smeg P662B-1 User Manual

 

 

 

 

 

INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED 
TECHNICIAN WHO MUST INSTALL THE APPLIANCE, SET IT FUNCTIONING AND CARRY OUT 
AN INSPECTION TEST. 

 

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE GROUNDED ACCORDING TO THE 
METHODS REQUIRED BY SAFETY RULES. 

 

WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT BOTH ARE 
COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE COMPLYING WITH 
APPLICABLE REGULATIONS. 
THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN BUILT IN. 
NEVER UNPLUG BY PULLING ON THE CABLE. 

 

ALWAYS CHECK THAT THE CONTROL ARE IN THE POSITION  0 (OFF) WHEN YOU FINISH 
USING THE HOB. 

 

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE 
SURFACE OF THE HOB. 

 

THE APPLIANCE IS NOT INTENDED FOR USE BY YOUNG CHILDREN OR INFIRM PERSONS 
WITHOUT SUPERVISION. 
YOUNG CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH 
THE APPLIANCE. 

 

WARNING: IF THE SURFACE IS CRACKED, SWITCH OFF THE APPLIANCE TO AVOID THE 
POSSIBILITY OF AN ELECTRIC  SHOCK 

 

THE APPLIANCE BECOMES VERY HOT DURING USE.  SUITABLE HEAT-PROOF GLOVES 
SHOULD BE WORN FOR ALL OPERATIONS. 

 

BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND PROTECTIVE 
FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED. 

 

THE POWER LEAD MUST BE CHANGED BY THE MANUFACTURER OR BY AN AUTHORISED 
SERVICE CENTRE TO PREVENT ANY RISKS. 

 

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION TEST OF THE 
APPLIANCE, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD THE APPLIANCE NOT 
FUNCTION, DISCONNECT IT FROM THE SUPPLY AND CALL THE NEAREST TECHNICAL 
ASSISTANCE CENTRE. 

 

NEVER ATTEMPT TO REPAIR THE APPLIANCE. ALL REPAIRS MUST BE CARRIED OUT BY AN 
AUTHORISED ENGINEER OR AT AN AUTHORISED SERVICE CENTRE.