Smeg PGFA95F-1 User Manual

 

Create an opening with the dimensions 
shown in the figure in the work surface, 
observing a minimum distance of  50 mm 
from the rear edge. 
The lower part of the protective cover must 
be fully accessible when the appliance is 
installed. This appliance can be installed 
next to walls that are higher than the  

1) 

the work surface, as long as the distance "X" is kept, as shown in the figure, to avoid 
damage from overheating. Make sure there is a minimum of 750 mm (Fig. 1) between 
the gas rings and any shelf that may be installed directly above them. 

This type of appliance requires the worktop, the 
dimensions of which are shown shown in figure 
2, to be milled to a depth of 2.5 mm. Before 
positioning the hob, position the adhesive 
sponge material “E” supplied over the milled 
surface (fig. 3). Having done this, place the hob 
on the milled surface and using the screws and 
fixing brackets “C” or “D” (depending on  the 
depth of the worktop) secure the hob to the 

2) 

support structure, ensuring, ensuring it is level. 
The brackets “C” secure the hob to a structure 
having a depth of 20 to 30 mm. The brackets 
“D” on the other hand, are for use with worktops 
having a depth of 30 to 50 mm. 

3) 

 

 

 

8