Lucent Technologies 5 User Manual
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
System Manager’s Guide
555-650-118
Issue 1
June 1997
System Components
Page 3-7
Control Unit
3
NOTE:
The MERLIN LEGEND MAIL® Voice Messaging System integrates a T/R
module with a voice messaging system and is both a module and an
application.
module with a voice messaging system and is both a module and an
application.
Modules Supporting Lines/Trunks
3
summarizes the modules that support lines/trunks. This section
describes a few module features and modules that need additional explanation.
NOTE:
Modes of operation affect features and hardware. For example, Direct
Inward Dial is supported only in Hybrid/PBX mode, so if your system uses
a different mode of operation, you do not need a DID module. For more
information about modes, see
Inward Dial is supported only in Hybrid/PBX mode, so if your system uses
a different mode of operation, you do not need a DID module. For more
information about modes, see
.
Power-Failure Transfer Telephones
3
When your system was planned, the Lucent Technologies representative(s) made
sure that you had a module to support one or more power-failure transfer (PFT)
telephones. These telephones, which are connected to a special line/trunk jack,
allow you to make and receive calls during a commercial power failure. They do
not affect the capacity of the modules.
sure that you had a module to support one or more power-failure transfer (PFT)
telephones. These telephones, which are connected to a special line/trunk jack,
allow you to make and receive calls during a commercial power failure. They do
not affect the capacity of the modules.
100D Module
3
The 100D module has only one line/trunk (called a
Digital Signal Level 1
or
DS1
facility) but actually supports 23 or 24 “virtual” lines/trunks. These are called
channels
or
B-channels
, depending upon the type of service you choose. As
described in
, you can program the DS1 facility to
provide either T1 or Primary Rate Interface (PRI) service on the 100D module.
NOTE:
The 100D module is not available in Behind Switch mode.
In addition, PRI and T1 support Group IV (G4) fax machines as well as desktop
and group videoconferencing.
and group videoconferencing.
PRI and T1 differ in some important ways:
■
Primary Rate Interface (PRI). PRI supports Integrated Services Access,
also called
also called
Shared Access for Switched Services (SASS)
and
Call-by-Call
Service Selection
. This feature, available from various telecommunications
companies, allows multiple PRI services to use the same facilities,
eliminating the need to have dedicated, separate incoming and outgoing
B-channel groups. It selects the optimal service for each outgoing call,
allowing more than one service over each B-channel, including digital data
communications at speeds up to 64 kilobits per second.
eliminating the need to have dedicated, separate incoming and outgoing
B-channel groups. It selects the optimal service for each outgoing call,
allowing more than one service over each B-channel, including digital data
communications at speeds up to 64 kilobits per second.