Lucent Technologies 555-670-116 User Manual

Page of 153
MERLIN LEGEND Communications System Release 7.0
Pocket Reference  
555-670-116  
Issue 1
April 1999
 
33
Environmental Specifications 
DS1 interface can be configured for connection of either T1 or PRI 
for basic call control with the 4ESS or 5ESS PRI service 
specifications. 
Basic Rate interface (BRI) S/T protocol supports premier digital 
multiline (MLX) telephones with superior display capabilities and 
supports the ISDN terminal adapter Data Module for the connection 
of adjuncts.
Environmental Specifications
The control unit requires a regulated environment and can be 
located in any room or closet that is temperature-controlled and 
clean. Do not mount the control unit where it will be exposed to direct 
sunlight.
In addition, the control unit should not be co-located with air 
conditioning or ventilation units, compressors, fans and blowers, 
heaters, arc welders, or other machinery that produces electrical 
interference.
The control unit is mounted on a Lucent Technologies pre-drilled 
backboard.
Once installed, it is important to keep the control unit site clear of 
hazards, such as stacked paper or boxes, that block ventilation. 
Installing any machinery in the vicinity of the control unit should be 
avoided. If any pollution-producing work (such as sanding or spray 
painting) is to be done in the area, care should be taken to protect 
the unit.
The following table gives the environmental specifications for the 
control unit.
Control Unit 
Fully loaded basic carrier
Weight:
45 lb. (20.4 kg)
Dimensions:
14 inches wide x 23 inches high x 12 inches 
deep
(35.6 cm x 58.4 cm x 30.5 cm)
Fully loaded 2-carrier system
(basic carrier plus 1 expansion carrier)
Weight:
90 lb. (40.8 kg)
Dimensions:
25 inches wide x 23 inches high x 12 inches
deep
(63.5 cm x 58.4 cm x 30.5 cm)
Fully loaded 3-carrier system
(basic carrier plus 2 expansion carriers)
Weight:
135 lb. (61.2 kg)
Dimensions:
37 inches wide x 23 inches high x 12 inches
deep
(94 cm x 58.4 cm x 30.5 cm)
Mean Time between Failures 
(mean/average time the system is expected to operate before any 
type of failure occurs) = 2.4 years for a system configured with 24 
trunks and 50 stations (extensions).