Toshiba 4511 User Manual

e-STUDIO3511/4511 ADJUSTMENT

3 - 10

November 2003  ©  TOSHIBA TEC

1. While pressing [0] and [5] simultaneously, turn the power ON.  

→  (Adjustment Mode)

2. Press [1] 

→  [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the

lower drawer.)

3. Measure the distance A from the 1st line to the 21st line of the grid pattern.

4. Check if the distance A is within 200±0.5 mm.

5. If not, use the following procedure to change values and measure the distance A again.

<Procedure>

(Adjustment Mode) 

→ (Key in the code [401]) → [START]

→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER]  or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed.
→ Press [1] → [FAX] → (A grid pattern is printed out.)
** The larger the adjustment value is, the longer the distance A becomes (approx.

0.05 mm/step).

1. While pressing [0] and [5] simultaneously, turn the power ON. 

→ (Adjustment Mode)

2. Press [1] 

→ [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the lower

drawer.)

3. Measure the distance B from the left edge of the paper to the 6th line of the grid pattern.

4. Check if the distance B is within 52±0.5 mm.

5. If not, use the following procedure to change values and measure the distance B again.

<Procedure>

(Adjustment Mode) 

→ (Key in the code [411]) → [START]

→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed
→ Press [1] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance B becomes (approx.

0.04 mm/step).

6. After the adjustment for the code 411 is completed, apply the same adjustment value for the

code 410.

<Procedure>

(Adjustment Mode) 

→ (Key in the code [410]) → [START]

→ (Key in the same value in the step 5 above)
→ [ENTER] or [INTERRUPT] (Stored in memory)

Make sure the 1st line of the grid pattern is printed out since the line is occasionally vanished.

04/09