Toshiba 4511 User Manual

November 2003 © TOSHIBA TEC

3 - 91

e-STUDIO3511/4511 ADJUSTMENT

3.16 Adjustment of Transfer Belt Deviation

3.16.1 Outline

If any transfer belt deviation (See 3.16.2) occurs when the equipment is installed, moved to another

place or the transfer belt is replaced, perform this adjustment.

3.16.2 Transfer belt deviation

Transfer belt deviation means that the transfer belt is not in the following normal condition. Check the

equipment and if the transfer belt does not conform to the conditions described below, perform the

adjustment according to the adjustment procedure of 3.16.3.

(1)

Open the 2nd transfer unit and check the gaps between both ends of the transfer belt and the

regulation plates. They should be 0.2 mm or more.

(2)

The gaps remain the same after the transfer belt has been rotated for 3 minutes or more. (The

belt should not be dislocated to the front or rear side.)

Fig. 3-1601

05/03

0.2mm or more