Intel SE7501WV2 User Manual

8197 

CPU Speed mismatch 

Yes 

8198 

Failed to load processor microcode 

Yes 

8300 

Baseboard Management Controller failed to function 

Yes 

8301 

Front Panel Controller failed to Function 

Yes 

8305 

Hotswap Controller failed to Function 

Yes 

8420 

Intelligent System Monitoring Chassis Opened 

Yes 

84F1 

Intelligent System Monitoring Forced Shutdown 

Yes 

84F2 

Server Management Interface Failed 

Yes 

84F3 

BMC in Update Mode 

Yes 

84F4 

Sensor Data Record Empty 

Yes 

84FF 

System Event Log Full 

No 

8500 

Bad or missing memory in slot 3A 

Yes 

8501 

Bad or missing memory in slot 2A 

Yes 

8502 

Bad or missing memory in slot 1A 

Yes 

8504 

Bad or missing memory in slot 3B 

Yes 

8505 

Bad or missing memory in slot 2B 

Yes 

8506 

Bad or missing memory in slot 1B 

Yes 

8601 

All Memory marked as fail. Forcing minimum back online 

Yes 

Prior to system video initialization, the BIOS uses these beep codes to inform users of error 
conditions. Short beeps will be generated and an error code will be POSTed on the POST 
Progress Code LEDs.  

In the case of a Bootblock update, where video is not available for text messages to be 
displayed, speaker beeps are necessary to inform the user of any errors. The following table 
describes the type of error beep codes that may occur during the Bootblock update. 

1 Recovery 

started 

 

Start recovery process 

2 Recovery 

boot error 

Flashing series of POST 
codes:  
E9h 
EEh 
EBh 
ECh 
EFh 

Unable to boot to floppy, ATAPI, or ATAPI CD-
ROM. Recovery process will retry. 

Series of long 
low-pitched 
single beeps 

Recovery 
failed 

EEh 

Unable to process valid BIOS recovery images. 
BIOS already passed control to operating system 
and flash utility. 

2 long high-
pitched beeps 

Recovery 
complete 

EFh 

BIOS recovery succeeded, ready for power-down, 
reboot.