Emerson 600 User Manual

20°

11. Adjust the tension screw until the proper belt tension is

recorded by the Browning Belt Tension Checker. The
recommended deflection force is 150 percent of the Edge
value or the value given for a new belt in form 5453 included
with the Browning Belt Tension Checker

WARNING! The surface on which the Motor Base is mounted must be flat. A base that is distorted or warped will not function

properly. If the surface is not flat, correct the condition with shims.

Maintenance

Lubrication

The carriage tubes are provided with holes or fitting for lubrication. Every six months or as dictated by the application, wipe down the
carriage rails and tension rod with an oily rag and apply a light grade grease. Be sure to remove all foreign material from the tubes
and tension rod.

Changing Belts

Turn the tension rod counter clockwise to move the carriage enough to allow the old belt to be removed.
Repeat steps 7 through 11 of the installation instructions to install the new belt.

Adjusting Belts

Periodic adjustment should not be needed. However, if it is suspected that the belt tension is not correct, then complete steps 10 and
11 of the installation instructions.

Allowable Mounting Positions

Floor Mounted

Ceiling Mounted

Wall Mounted Driven

beside Driver

Browning, Emerson and Emerson Industrial Automation are trademarks of Emerson

Electric Co. or one of its affiliated companies.

MCIM14006E • Form 9884E • Printed in USA

Wall Mounted Driven

Above Driver

All other mounting positions contact Application Engineering.