KitchenAid KBGN292 User Manual

Remove side burner cover. Do not light
burners with the cover on.

Light only one burner at a

time.

1. Do not lean over burners. Push in and

turn to "LITE" the control knob for the
burner you wish to use.

2. Push in the burner ignitor button. You

will hear the “snapping” sound of the
spark. Keep the burner ignitor button
pushed in until burner lights. Make sure
burner is lit. Repeat for the other
burner as needed.

If burner does not light immediately, turn the
burner knob to “OFF” and wait 5 minutes
before relighting.

Light only one burner at a

time.

1. Do not lean over burners. Push in and

turn to "LITE" the control knob for the
burner you wish to use.

2. Push in the burner ignitor button. You

will hear the “snapping” sound of the
spark. Keep the burner ignitor button
pushed in until burner lights. Make sure
burner is lit. Repeat for each of the
other burners as needed.

If burner does not light immediately, turn the
burner knob to “OFF” and wait 5 minutes
before relighting.

1. Open the hood completely. Do not light

burners with the hood closed.

2. Make sure

control knobs are
turned to OFF.
The drip pan
must be in place
and pushed all
the way to the
back.

1. For portable grills using an L.P./

propane gas cylinder:

Slowly open the cylinder valve; do not
“snap” open.

If flow limiting device does

activate, your grill may not light. If your
grill does light, the flames will be low
and will not heat properly. Turn cylinder
valve and all control knobs off and wait
30 seconds. After shutting off the
cylinder, very slowly open cylinder
valve and wait 5 seconds before
lighting.

2. For grills using gas supply source other

than L.P. gas cylinder:

Turn the shut off valve to open position

from the front of gas supply line.

4. Carefully guide the lit match between

the grill grate and one of the slots in
the sear plate.

5. Push in and turn the burner knob to

“LITE” for the burner closest to the lit
match. The burner will light immediately.

6. Repeat steps 2 through 5 for each

main burner.

7. Replace manual lighting extension

inside the drip tray.

If burner does not light immediately, turn the
burner knob to “OFF” and wait 5 minutes
before relighting.

If any burners do not light after attempting
to manually light them, contact the
KitchenAid Assistance Center.

1. Remove the manual lighting extension

from inside the drip tray.

2. Attach a match to the clip.

3. Strike the match to light it.